Factory supplied 10a 250v Italy Imq Approval Chile Power Cord Ca - korea 3 pin plug C5 Power cord – Komikaya

Product Details

Technical requirements

1. All materials must comply with the latest ROHS&REACH standards and environmental protection requirements

2. The mechanical and electrical properties of plugs and wires must comply with the PSE standard

3. The writing on the power cord must be clear, and the appearance of the product must be kept clean

Electrical performance test

1. There should be no short circuit, short circuit and polarity reversal in the continuity test

2. The pole-to-pole withstand voltage test is 2000V 50Hz/1 second, and there should be no breakdown

3. The pole-to-pole withstand voltage test is 4000V 50Hz/1 second, and there should be no breakdown

4. The insulated core wire should not be damaged by stripping the sheath

More introduction about this item

1. Environmental PVC material Jacket

Insulation is used outside the environmental protection of hard
Polyvinyl chloride material wire safety, wear, durable and avoid around

2. Oxygen-free copper wire core

Conductor with oxygen-free copper wire core, conductive
Good, small resistance, anti-oxidation, fast and stable transmission

3. Standard word tail socket

Universal word tail interface, the internal use of pure copper plug combination,
Resistant to plug, practical and safe

4. Plug with safety tube

The safety tube protects the safety of daily electricity

5. New tinned copper

Effectively ensure good contact with the product good electrical conductivity

6. Epidermis / Plug / Copper core

Achieve extraordinary quality

FAQs

What is your Warranty?

A5: All the products will have 12 months Warranty

What payment method do you accept?

T/T(Bank transfer), Western Union, Paypal, etc.

Scope of application

Common defective Phenomenon

1.Whether the parameters of the testing machine meet the regulations and whether the testing method is correct

2.Whether there are any electrical defects such as disconnection, short circuit, wrong threading, etc.

3. Whether the performance of the tester is normal, and whether qualified and defective products can be measured on time

4. Whether qualified products and defective products are distinguished in time

Put defective products in the red plastic box